How To Change IPG 1000W Fiber Laser Power

May 8, 2024

Are you looking to change the power of your IPG 1000W fiber laser? The process may seem daunting, but it can be done with a few simple


steps. Here's how:

Step 1: Turn off the laser and disconnect it from any power source. Make sure the laser is cool before proceeding.

Step 2: Remove the cover of the laser head and locate the power-adjusting switch. This will vary depending on the specific model of your laser.

Step 3: Using a small screwdriver, adjust the power adjusting switch to the desired power output. Be careful not to apply too much pressure or


adjust it too quickly, as this can damage the laser.

Step 4: Replace the cover of the laser head and reconnect the laser to its power source.

Step 5: Turn on the laser and test it at the new power output. If everything is working correctly, you should notice a difference in the laser's



It's important to note that changing the power of a fiber laser should only be done by a trained professional with experience working with


lasers. If you're unsure about the process or feel uneasy about performing it yourself, it's best to contact a professional to help you.

In addition, it's important to follow proper safety precautions when working with lasers, including wearing the appropriate protective gear and


following all safety guidelines outlined in the laser's manual.

By following these steps and taking the necessary safety precautions, you can change the power output of your IPG 1000W fiber laser and get


the most out of its performance.